Vandy Vape Mesh 24 RTA - Rebuildable Tank Atomizer
The Vandy Vape Mesh 24 RTA is the rebuildable tank atomizer version of the original Mesh RDA. The Mesh 24 RTA features an all new design with a dual post clamp build deck with two screws on each post. The Mesh 24 RTA is designed specifically for mesh wire only. The Mesh 24 RTA
utilizes the clamp posts to conveniently secure and lock in the mesh
wire. Get tremendous flavor with the use of the included stainless steel 316L mesh wire. The Mesh 24 RTA features a 2.0ml e-Liquid capacity and may be increased to 4.0ml using the included replacement glass tube. The Mesh 24 RTA features a leak resistant top airflow design with adjustable dual airflow slots. The Mesh 24 RTA includes (1) resin wide bore drip tip, (1) ULTEM wide bore drip tip and (1) delrin doc drip tip.
No two resin products will ever have the same design and look due to the unique manufacturing process. ULTEM is a high temperature plastic with a significantly higher melting point compared to Delrin. ULTEM is also a very hard material, making it a suitable choice when threading into stainless steel.
Quick Links: Our Premium e-Liquid Wick, Wire and Tools
Features and Specs:
- Designed for Use with Mesh Wire
- Dimensions: 2" x 15/16" (Including Drip Tip and Threads)
- 24mm Diameter
- 510 Threaded
- 2.0ml Capacity (4.0ml with Included Replacement Glass Tube)
- Dual Post Clamp Design with Four Screws
- Utilizes Clamp Post to Secure Mesh Wire
- Top Fill with Slide Out Design
- Leak Resistant Top Airflow Design
- Dual Airflow Slots
- Adjustable Top Airflow Control Ring
- Includes Stainless Steel 316L Mesh Wire
- Includes (1) Resin Wide Bore Drip Tip, (1) ULTEM Wide Bore Drip Tip and (1) Delrin Doc Drip Tip
- Includes 510 Drip Tip Adapter
Rebuildable atomizer: The user of this atomizer must install wick and wire (coil) in order to use it. This atomizer is not pre-installed with coil. Installation is required. Wick, wire and mesh sold separately.
Important Note: Rebuildable atomizer coils and wicks have known risks.
Rebuildables are for experts, not average or beginner vapers with no multimeter or knowledge of how to use a meter, or when a meter must be used, or how electronic devices work. These materials cannot safely be used by the inexperienced or those without basic knowledge of electronics.
This is because:
1. A rebuildable coil/wick MUST be tested carefully with a meter before it is used. 2. If it is not tested it is entirely the risk of the user. 3. Faulty wicks/coils WILL blow electronic devices. 4. New coil/wick units must be tested and then used first on a strong basic electrical APV that has short circuit protection. 5. No new coil/wick assembly should be used on an electronic device until known to be safe. 6. These items destroy electronic devices if faulty. This is a known issue.
Due to the nature of this product there is no warranty. This product is for experienced users and requires technical knowledge in order to properly use it.
Tips for new nicotine users: Sub-ohm or low resistance atomizers produce a higher throat hit than standard,high resistance atomizers. We strongly suggest 3 to 6mg eLiquid or lower with sub-ohm or low resistance atomizer heads. Preference may vary depending on the user and frequency of use.
For standard,high resistance atomizers or restrictive devices (ex. pod based,pen), we recommend 6mg or higher due to the mouth to lung (MTL) design of this atomizer,tank. Preference may vary depending on the user and frequency of use.
Warning: Sub ohm or low resistance tanks should only be used by experienced users. Extra safety precautions should be practiced when using a sub ohm tank. This tank will only work on a mechanical mod or a regulated mod capable of firing sub ohm atomizers and coils. For example, if you have a 0.2ohm coil, your mod must be able to fire atomizers of 0.2ohm or lower. You must also ensure that your batteries can handle sub ohm atomizers and coils. If you're using a regulated mod, make sure it can handle the amps. Improper use can lead to injury or damage. For mechanical mod users, please use 20 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.
Battery Safety Warning:
Use special caution when using Li-Ion cells, they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure you have enough knowledge of Li-Ion rechargeable batteries in charging, discharging and assembly before use.
Do not let your batteries come into contact with metal objects such as keys, loose change or any other metal objects. Doing so will put you at risk for short circuiting your battery and explosion. Do not put loose batteries in your pocket, purse, bag or anywhere else. When the battery is not in use, you must store it in a plastic battery case to reduce the risk of a battery explosion.
Always charge in or on a fire-proof surface. Never leave charging batteries unattended.
Do not modify batteries or chargers in any shape or form.
Only use Lithium Ion rechargeable batteries in devices that have a built in protection circuit board(PCB) that detect shorts, over-discharge, over-charging etc. Use of lithium ion batteries without a PCB may increase your risk or explosion and,or fire.
Store your batteries away from the sun and heat to prevent overheating your batteries.
Please be sure to inspect your battery before use to ensure it is not damaged including tears or rips in the battery wrap. Discontinue use immediately if battery is damaged.
Do not discharge batteries below 2.5V. Do not charge the batteries over 4.2V.
myvaporstore.com will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a Li-Ion battery. Please have a basic understanding of the batteries you are using and how to care for them properly.
|