Innokin Ares V2 RTA by Phil Busardo and Dimitris Agrafiotis - Rebuildable Tank Atomizer for MTL Vaping
Platform Series

The Innokin Ares 2 RTA is a collaboration between Phil Busardo, Dimitris Agrafiotis, and Innokin. The Ares 2 has many new improvements to provide the most satisfying vaping experience possible. The top cap and seals have been improved to minimize liquid and air seepage. The top cap and silicone top fill seal are both removable now. The bottom seals have also been improved with a new 0.8mm airhole allowing for a tighter mouth to lung (MTL) selection. Detents have been added to the bottom airflow selector to allow for easier and more accurate settings.

From the manufacturer:

New Cross Air Flow Control (CAFC)

This change is the one we're most excited about. In addition to the standard outside airflow control, we've added the new Cross Air Flow Control (CAFC) located under the coil. Use the CAFC in conjunction with the standard AFC to find your perfect draw.

We wanted to give you the ability to change the velocity and air pattern under the coil without having to change parts or remove the coil. The CAFC allows you to change the airflow from a tiny hole to a larger slot running the length of the coil, and everything in between because it is completely adjustable.

Same Flavor Bell and Liquid Barriers

Inside the atomizer, you'll still find the same flavor bell that condenses the vapor providing a smooth and flavorful mouth to lung vape with all the throat hit you may need. You'll also find the same liquid barriers, designed to keep the cotton off the airflow under the coil to help prevent directing liquid out the airflow.

More Convenient

We've improved the top cap and seals to prevent liquid and air seepage. We've given you the ability to remove the top cap and replace the fill port seal if required. The top cap also features a child-resistant design. Removing the mouthpiece first allows the top cap to slide open. With the mouthpiece in place, the cap is locked closed.

Full Set of Accessories

The Ares 2 will come with the full set of accessories found with the Ares 1 including two build tools, a screwdriver, pre-built kanthal coils, loose kanthal wire, and organic cotton to get you up and running as soon as possible.

All About Balance

The Ares has always been an atomizer about balance; balance between features, ease of use, and vape quality. We hope you enjoy the improvements made to the Ares 2 and hope you love it as much as we do!

Quick Links:
Our Premium e-Liquid
Wick, Wire and Tools
Replacement Glass

Features and Specs

• Designed in Collaboration with Phil Busardo and Dimitris Agrafiotis the VapinGreek
• Designed for Mouth to Lung (MTL)
• Dimensions: (Including Drip Tip and Threads)
• Diameter: 24mm
• 510 Threaded
• E-Liquid Capacity: 4.0ml
• Improved Removable Top Cap and Seal
• New 0.8mm Airhole
• New Cross Airflow Control (CAFC)
• More Accurate Airflow Selection
• Drop-in Coil Sky Build Deck for Single Coil Builds
• Top Fill Design with Slide Out Fill Hole
• Liquid Barrier to Minimize Leaks
• Rounded Bell Chamber to Reduce Air Turbulence
• Adjustable Single Airflow Slot and Single Airflow Hole
• Five Different Sized Airflow Holes
• Includes Two Different Build Tools

---

Rebuildable atomizer: The user of this atomizer must install wick and wire (coil) in order to use it. This atomizer is not pre-installed with coil. Installation is required. Wick, wire and mesh sold separately.

---

Important Note:
Rebuildable atomizer coils and wicks have known risks.

Rebuildables are for experts, not average or beginner vapers with no multimeter or knowledge of how to use a meter, or when a meter must be used, or how electronic devices work. These materials cannot safely be used by the inexperienced or those without basic knowledge of electronics.

This is because:

1. A rebuildable coil/wick MUST be tested carefully with a meter before it is used.
2. If it is not tested it is entirely the risk of the user.
3. Faulty wicks/coils WILL blow electronic devices.
4. New coil/wick units must be tested and then used first on a strong basic electrical APV that has short circuit protection.
5. No new coil/wick assembly should be used on an electronic device until known to be safe.
6. These items destroy electronic devices if faulty. This is a known issue.

Due to the nature of this product there is no warranty. This product is for experienced users and requires technical knowledge in order to properly use it.

---

Tips for new nicotine users: Sub-ohm or low resistance atomizers produce a higher throat hit than standard,high resistance atomizers. We strongly suggest 3 to 6mg eLiquid or lower with sub-ohm or low resistance atomizer heads. Preference may vary depending on the user and frequency of use.

For standard,high resistance atomizers or restrictive devices (ex. pod based,pen), we recommend 6mg or higher due to the mouth to lung (MTL) design of this atomizer,tank. Preference may vary depending on the user and frequency of use.

Warning: Sub ohm or low resistance tanks should only be used by experienced users. Extra safety precautions should be practiced when using a sub ohm tank. This tank will only work on a mechanical mod or a regulated mod capable of firing sub ohm atomizers and coils. For example, if you have a 0.2ohm coil, your mod must be able to fire atomizers of 0.2ohm or lower. You must also ensure that your batteries can handle sub ohm atomizers and coils. If you're using a regulated mod, make sure it can handle the amps. Improper use can lead to injury or damage. For mechanical mod users, please use 20 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.

Battery Safety Warning:

Use special caution when using Li-Ion cells, they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure you have enough knowledge of Li-Ion rechargeable batteries in charging, discharging and assembly before use.

Do not let your batteries come into contact with metal objects such as keys, loose change or any other metal objects. Doing so will put you at risk for short circuiting your battery and explosion. Do not put loose batteries in your pocket, purse, bag or anywhere else. When the battery is not in use, you must store it in a plastic battery case to reduce the risk of a battery explosion.

Always charge in or on a fire-proof surface. Never leave charging batteries unattended.

Do not modify batteries or chargers in any shape or form.

Only use Lithium Ion rechargeable batteries in devices that have a built in protection circuit board(PCB) that detect shorts, over-discharge, over-charging etc. Use of lithium ion batteries without a PCB may increase your risk or explosion and,or fire.

Store your batteries away from the sun and heat to prevent overheating your batteries.

Please be sure to inspect your battery before use to ensure it is not damaged including tears or rips in the battery wrap. Discontinue use immediately if battery is damaged.

Do not discharge batteries below 2.5V. Do not charge the batteries over 4.2V.

myvaporstore.com will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a Li-Ion battery. Please have a basic understanding of the batteries you are using and how to care for them properly.