GOON LP Low Profile RDA by 528 Custom
GOON LP Low Profile RDA by 528 Custom features the same famous build quality of the previous GOON RDAs with a innovative design twist. The bridge post and clamps are now horizontal allowing for a wider and taller variety of coil builds. The low profile design brings out the pure flavor of your favorite e-Liquid. The positive and negative posts are gold plated and features PEEK insulators for great conductivity and insulation.
The designer of the GOON RDA, Blueeyedgoon83 is well known for their intricate and beautiful builds. The size of the post holes inside the "Bridge Clamp" design are unmatched in the industry allowing for many different and varied builds. This design features a flat surface with another bridge on the side of the surface. You can simply put your built coil on the surface and screw down the bridge onto the surface, making a connection!
The GOON LP RDA includes a ULTEM wide bore drip, ULTEM top cap and a ULTEM sleeve. ULTEM is a High-Temperature plastic with a significantly higher melting point compared to Delrin. ULTEM is also a very hard material, making it a suitable choice when threading into stainless steel. Give your GOON LP RDA a fresh look while enjoying the comfort of these caps.
Quick links: Wick, Wire and Tools
Features and Specs:
- Dimensions: 1-3/16" x 15/16" (Including Drip Tip and Threads)
- 24mm Diameter
- 510 Threaded
- Dual Adjustable Airflow Slots
- ULTEM Wide-bore Drip Tip
- Gold Plated 510 Contact Pin
- Gold Plated Horizontal Bridge Post
- Gold Plated Stainless Steel Horizontal Clamps
- Hybrid Safe
- PEEK Insulators
- Positive and Negative Bridges are Easily Replaceable
- Includes ULTEM Drip Tip, ULTEM Top Cap, ULTEM Sleeve, Bottom Feeding Squonker Pin and Extra Screws and O-Rings
- Unique Serial Number
Rebuildable
atomizer: The user of this atomizer must install wick and wire (coil) in
order to use it. This atomizer is not pre-installed with coil.
Installation is required. Wick, wire and mesh sold separately.
Important Note: Rebuildable atomizer coils and wicks have known risks.
Rebuildables are for experts, not average or beginner vapers with no multimeter
or knowledge of how to use a meter, or when a meter must be used, or
how electronic devices work. These materials cannot safely be used by
the inexperienced or those without basic knowledge of electronics.
This is because:
1. A rebuildable coil/wick MUST be tested carefully with a meter before it is used. 2. If it is not tested it is entirely the risk of the user. 3. Faulty wicks/coils WILL blow electronic devices. 4. New coil/wick units must be tested and then used first on a strong basic electrical APV that has short circuit protection. 5. No new coil/wick assembly should be used on an electronic device until known to be safe. 6. These items destroy electronic devices if faulty. This is a known issue.
Due to the nature of this product there is no warranty. This product is
for experienced users and requires technical knowledge in order to
properly use it.
Tips for new nicotine users: Sub-ohm or low resistance atomizers produce a higher throat hit than standard,high resistance atomizers. We strongly suggest 3 to 6mg eLiquid or lower with sub-ohm or low resistance atomizer heads. Preference may vary depending on the user and frequency of use.
For standard,high resistance atomizers or restrictive devices (ex. pod based,pen), we recommend 6mg or higher due to the mouth to lung (MTL) design of this atomizer,tank. Preference may vary depending on the user and frequency of use.
Warning: Sub ohm or low resistance tanks should only be used by experienced users. Extra safety precautions should be practiced when using a sub ohm tank. This tank will only work on a mechanical mod or a regulated mod capable of firing sub ohm atomizers and coils. For example, if you have a 0.2ohm coil, your mod must be able to fire atomizers of 0.2ohm or lower. You must also ensure that your batteries can handle sub ohm atomizers and coils. If you're using a regulated mod, make sure it can handle the amps. Improper use can lead to injury or damage. For mechanical mod users, please use 20 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.
Battery Safety Warning:
Use special caution when using Li-Ion cells, they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure you have enough knowledge of Li-Ion rechargeable batteries in charging, discharging and assembly before use.
Do not let your batteries come into contact with metal objects such as keys, loose change or any other metal objects. Doing so will put you at risk for short circuiting your battery and explosion. Do not put loose batteries in your pocket, purse, bag or anywhere else. When the battery is not in use, you must store it in a plastic battery case to reduce the risk of a battery explosion.
Always charge in or on a fire-proof surface. Never leave charging batteries unattended.
Do not modify batteries or chargers in any shape or form.
Only use Lithium Ion rechargeable batteries in devices that have a built in protection circuit board(PCB) that detect shorts, over-discharge, over-charging etc. Use of lithium ion batteries without a PCB may increase your risk or explosion and,or fire.
Store your batteries away from the sun and heat to prevent overheating your batteries.
Please be sure to inspect your battery before use to ensure it is not damaged including tears or rips in the battery wrap. Discontinue use immediately if battery is damaged.
Do not discharge batteries below 2.5V. Do not charge the batteries over 4.2V.
myvaporstore.com will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a Li-Ion battery. Please have a basic understanding of the batteries you are using and how to care for them properly.
|