Wismec Luxotic Surface 80W Squonk Mod with Kestrel Tank Squonk Kit
The Wismec Luxotic Surface Squonk vape mod builds upon the Wismec Luxotic series with an all new redesign and numerous improvements designed for the squonking enthusiast. The Luxotic Surface features a bottom feeding design with a 6.5ml capacity juice delivery system. Simply squeeze the squonk bottle located inside the Luxotic Surface into your favorite bottom feeding RDA or RTA for pure flavor and satisfaction. The Luxotic Surface is powered by the Avatar chip which can fire up to 80 watts and supports multiple temperature control modes. The Luxotic Surface also features a bypass mode, preheat function, and a stealth mode as well. The Luxotic Surface can fire at an almost instantaneous firing speed for immediate satisfaction. The Luxotic Surface features a compact box design with a stylized front panel. The Luxotic Surface is powered by (1) high amp 18650 battery (sold separately) and requires an external battery charger (sold separately) to recharge your batteries.
The Wismec Kestrel tank features a unique RDTA (rebuildable tank atomizer) design that doesn't utilize a traditional coil like other tanks. The Kestrel utilizes a unique Kestrel kanthal mesh heater which features a larger heating area and a longer life span compared to traditional coils. The Kestrel heater can be easily rewicked using the included cotton pad. The Kestrel comes pre-installed with a bottom feeding squonker pin for squonk/bottom feeding mods. The Kestrel is finally topped off with a beautiful resin wide bore drip tip.
Quick Links: Our Premium e-Liquid Wick, Wire and Tools
Features and Specs for Wismec Luxotic Surface Mod:
- Powered by Avatar Chip
- Bottom Feeding Design
- Juice Delivery System
- 6.5ml Capacity Squonk Bottle (Pre-installed)
- Dimensions: 3-1/16" x 1-11/16" x 15/16" (Without Tank)
- Spring Loaded 510 Contact Pin
- Output Wattage: 1.0 - 80.0W
- Temperature Control: Nickel 200 (Ni200), Titanium (Ti), Stainless Steel 316 (SS316), TCR Mode
- Temperature Control Range: 100 - 315C / 200 - 600F
- Resistance Range: 0.05 - 3.5ohm
- Instant Firing Speed: 0.001s
- Bypass Mode
- Preheat Function
- Stealth Mode
- 0.49" OLED Display Screen
- Compact Box Design with Stylized Front Panel
- Requires (1) High Amp 18650 Battery (Sold Separately)
- Requires an External Battery Charger (Sold Separately)
- Includes Replacement Squonk Bottle
- Short Circuit Protection
- Temperature Protection
- Over-charge Protection
- Reverse Polarity Protection
Features and Specs for Wismec Kestrel Tank:
- Dimensions: 1-7/16" x 15/16" (Including Drip Tip and Threads)
- Diameter: 24mm
- 510 Threaded
- E-Liquid Capacity: 2.0ml
- RDTA Design
- Side Fill Design
- Glass Tank
- Dual Airflow Slots
- Adjustable Airflow Top Cap
- No Coil and Rewickable Design with Cotton Included
- Larger Heating Area
- Utilizes Wismec Kestrel Kanthal Mesh Heater 0.25ohm for Wattage
- Includes Bottom Feeding Squonker Pin for Squonk/Bottom Feeding Mods (Pre-installed)
- Resin Wide Bore Drip Tip
Rebuildable atomizer: The user of this atomizer must install wick and wire (coil) in order to use it. This atomizer is not pre-installed with coil. Installation is required. Wick, wire and mesh sold separately.
Important Note: Rebuildable atomizer coils and wicks have known risks.
Rebuildables are for experts, not average or beginner vapers with no multimeter
or knowledge of how to use a meter, or when a meter must be used, or
how electronic devices work. These materials cannot safely be used by
the inexperienced or those without basic knowledge of electronics.
This is because:
1. A rebuildable coil/wick MUST be tested carefully with a meter before it is used. 2. If it is not tested it is entirely the risk of the user. 3. Faulty wicks/coils WILL blow electronic devices. 4. New coil/wick units must be tested and then used first on a strong basic electrical APV that has short circuit protection. 5. No new coil/wick assembly should be used on an electronic device until known to be safe. 6. These items destroy electronic devices if faulty. This is a known issue.
Due to the nature of this product there is no warranty. This product is for experienced users and requires technical knowledge in order to properly use it
Tips for new nicotine users: Sub-ohm or low resistance atomizers produce a higher throat hit than standard,high resistance atomizers. We strongly suggest 3 to 6mg eLiquid or lower with sub-ohm or low resistance atomizer heads. Preference may vary depending on the user and frequency of use.
For standard,high resistance atomizers or restrictive devices (ex. pod based,pen), we recommend 6mg or higher due to the mouth to lung (MTL) design of this atomizer,tank. Preference may vary depending on the user and frequency of use.
Warning: Sub ohm or low resistance tanks should only be used by experienced users. Extra safety precautions should be practiced when using a sub ohm tank. This tank will only work on a mechanical mod or a regulated mod capable of firing sub ohm atomizers and coils. For example, if you have a 0.2ohm coil, your mod must be able to fire atomizers of 0.2ohm or lower. You must also ensure that your batteries can handle sub ohm atomizers and coils. If you're using a regulated mod, make sure it can handle the amps. Improper use can lead to injury or damage. For mechanical mod users, please use 20 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.
Battery Safety Warning:
Use special caution when using Li-Ion cells, they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure you have enough knowledge of Li-Ion rechargeable batteries in charging, discharging and assembly before use.
Do not let your batteries come into contact with metal objects such as keys, loose change or any other metal objects. Doing so will put you at risk for short circuiting your battery and explosion. Do not put loose batteries in your pocket, purse, bag or anywhere else. When the battery is not in use, you must store it in a plastic battery case to reduce the risk of a battery explosion.
Always charge in or on a fire-proof surface. Never leave charging batteries unattended.
Do not modify batteries or chargers in any shape or form.
Only use Lithium Ion rechargeable batteries in devices that have a built in protection circuit board(PCB) that detect shorts, over-discharge, over-charging etc. Use of lithium ion batteries without a PCB may increase your risk or explosion and,or fire.
Store your batteries away from the sun and heat to prevent overheating your batteries.
Please be sure to inspect your battery before use to ensure it is not damaged including tears or rips in the battery wrap. Discontinue use immediately if battery is damaged.
Do not discharge batteries below 2.5V. Do not charge the batteries over 4.2V.
myvaporstore.com will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a Li-Ion battery. Please have a basic understanding of the batteries you are using and how to care for them properly.
|