IGO-W8 Rebuildable Atomizer RDA

UD IGO-W8 (Jaw) Is Youde First 22mm Tri-Post Heat Fin Styled RDA That Performs and Looks Amazing. Best Of All, It's Ultra Original and Affordable!

• UD First Tri-Post Design Allowing Tri-Coil Build
• Beautifully Machined with SS and Brass two tone design
• Airflow Control
• Made of 304 Stainless Steel
• Deep Juice Well
• 22mm in Diameter to fit most of your Mods Flush!
• Heat Fin Design to disburse heat more efficiently
• 510 Threaded
• Drip Atomizer

• Sealed battery connector
• Phillips head screws for positive/negative post
• Fits most 510 drip tips
• Wick and wire sold separately

Dimensions: 1-3/8" x 7/8" (length x diameter)


Due to the nature of this product there is no warranty. This product is for experienced users and requires technical knowledge in order to properly use it.

---

Rebuildable atomizer: The user of this atomizer must install wick and wire (coil) in order to use it. This atomizer is not pre-installed with coil. Installation is required. Wick, wire and mesh sold separately.

---

Important Note:
Rebuildable atomizer coils and wicks have known risks.

Rebuildables are for experts, not average or beginner vapers with no multimeter or knowledge of how to use a meter, or when a meter must be used, or how electronic devices work. These materials cannot safely be used by the inexperienced or those without basic knowledge of electronics.

This is because:

1. A rebuildable coil/wick MUST be tested carefully with a meter before it is used.
2. If it is not tested it is entirely the risk of the user.
3. Faulty wicks/coils WILL blow electronic devices.
4. New coil/wick units must be tested and then used first on a strong basic electrical APV that has short circuit protection.
5. No new coil/wick assembly should be used on an electronic device until known to be safe.
6. These items destroy electronic devices if faulty. This is a known issue.

Tips for new nicotine users: Sub-ohm or low resistance atomizers produce a higher throat hit than standard,high resistance atomizers. We strongly suggest 3 to 6mg eLiquid or lower with sub-ohm or low resistance atomizer heads. Preference may vary depending on the user and frequency of use.

For standard,high resistance atomizers or restrictive devices (ex. pod based,pen), we recommend 6mg or higher due to the mouth to lung (MTL) design of this atomizer,tank. Preference may vary depending on the user and frequency of use.

Warning: Sub ohm or low resistance tanks should only be used by experienced users. Extra safety precautions should be practiced when using a sub ohm tank. This tank will only work on a mechanical mod or a regulated mod capable of firing sub ohm atomizers and coils. For example, if you have a 0.2ohm coil, your mod must be able to fire atomizers of 0.2ohm or lower. You must also ensure that your batteries can handle sub ohm atomizers and coils. If you're using a regulated mod, make sure it can handle the amps. Improper use can lead to injury or damage. For mechanical mod users, please use 20 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.

Battery Safety Warning:

Use special caution when using Li-Ion cells, they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure you have enough knowledge of Li-Ion rechargeable batteries in charging, discharging and assembly before use.

Do not let your batteries come into contact with metal objects such as keys, loose change or any other metal objects. Doing so will put you at risk for short circuiting your battery and explosion. Do not put loose batteries in your pocket, purse, bag or anywhere else. When the battery is not in use, you must store it in a plastic battery case to reduce the risk of a battery explosion.

Always charge in or on a fire-proof surface. Never leave charging batteries unattended.

Do not modify batteries or chargers in any shape or form.

Only use Lithium Ion rechargeable batteries in devices that have a built in protection circuit board(PCB) that detect shorts, over-discharge, over-charging etc. Use of lithium ion batteries without a PCB may increase your risk or explosion and,or fire.

Store your batteries away from the sun and heat to prevent overheating your batteries.

Please be sure to inspect your battery before use to ensure it is not damaged including tears or rips in the battery wrap. Discontinue use immediately if battery is damaged.

Do not discharge batteries below 2.5V. Do not charge the batteries over 4.2V.

myvaporstore.com will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a Li-Ion battery. Please have a basic understanding of the batteries you are using and how to care for them properly.